Whether you are estimating on the spot or checking a result somebody else gave you, the wind load calculator is the quickest way to get from air density, surface angle, surface area, wind velocity and sin to dynamic pressure and wind load.
What Is the Wind Load Calculator?
This wind load calculator is for the kind of problem where you know the physical quantities but not the number you need. It turns air density, surface angle, surface area, wind velocity and sin into dynamic pressure and wind load.
Physics calculations go wrong in predictable ways, usually through mixing units or dropping a digit. Work through the result one step at a time and check that the figures are the size you would expect at each stage.
How the Wind Load Physics Works
The relationship is applied step by step, and each step is a standard piece of physics rather than a single opaque formula. That means you can check the intermediate values against what the theory predicts, which is usually faster than checking only the final answer.
Keep every value in the same unit system throughout the calculation. Mixing metres and feet part way through is the single most common reason a correct formula gives a wrong answer.
Units, Assumptions and the Limits of the Model
The calculation assumes ideal conditions: no air resistance, no heat loss, and dimensions that do not change while you work. Those assumptions are reasonable for most classroom and engineering estimates, and unreasonable for anything more precise.
Where a value is a rate, it has to be quoted for the same period as everything else. A per-hour figure cannot be combined with a per-day figure without converting one of them first.
A Worked Example
Working through an example, with air density set to 10, surface angle set to 5, surface area set to 2, the calculator returns dynamic pressure of 50,000, and wind load of -95,892.42747. Substitute your own figures and the same steps produce the same kind of answer.
Frequently Asked Questions
What do I need to work out dynamic pressure?
Enter air density, surface angle, surface area, wind velocity and sin. The calculator then works through the relationship and reports dynamic pressure and wind load.
What does the wind load actually calculate?
It takes air density, surface angle, surface area, wind velocity and sin and converts them into dynamic pressure and wind load using the standard relationship for this problem. Each step is applied in turn, so every output is traceable back to the numbers you typed in.
How should I enter air density?
Use the value you actually have, in the unit shown next to the field. Enter every value in the same unit system. The calculator assumes the figures you supply are consistent, so it cannot correct a mistake that happens before the calculation starts.
Do I have to fill in every field?
Only the fields a particular result depends on. If you leave one blank, the results that need it simply show a note instead of a number, and everything else still works.
Why does a small change in one value move the answer so much?
That happens when an output depends on a ratio, because dividing by a small number magnifies any change in it. Check the units first, then check whether the value you entered is in the range the relationship was designed for.