Everyday whip (baseball) problems come down to one relationship between hits, innings and walks. This calculator turns those numbers into whip, with the working shown so you can check the result rather than simply trust it.
What Is the WHIP (Baseball) Calculator?
The whip (baseball) calculator turns hits, innings and walks into whip.
It is a quick way to get from the numbers you have to the number you need, without setting up a spreadsheet or reaching for a formula.
How the WHIP (Baseball) Works
Each result follows from the ones before it, and the calculator shows every step, so a surprising answer can be traced back to the input that caused it.
Round your inputs to the precision you actually know, and keep more precision than that in the intermediate steps.
Getting a Result You Can Trust
Run the calculation twice with slightly different inputs. A sensible calculator moves its output in proportion; a wild change points to a unit or a decimal point problem in what you entered.
Write the inputs down next to the answer. It takes a moment and it is the difference between a number you can explain and one you cannot.
A Worked Example
Working through an example, with hits set to 10, innings set to 5, walks set to 2, the calculator returns whip of 2.4. Substitute your own figures and the same steps produce the same kind of answer.
Frequently Asked Questions
What do I need to work out whip?
Enter hits, innings and walks. The calculator then works through the relationship and reports whip.
What does the whip (baseball) actually calculate?
It takes hits, innings and walks and converts them into whip using the standard relationship for this problem. Each step is applied in turn, so every output is traceable back to the numbers you typed in.
How should I enter hits?
Use the value you actually have, in the unit shown next to the field. Enter every value in the same unit system. The calculator assumes the figures you supply are consistent, so it cannot correct a mistake that happens before the calculation starts.
Does anything you type get stored?
No. The whole calculation runs inside your browser, and nothing you enter is uploaded, logged or sent anywhere.
Why does a small change in one value move the answer so much?
That happens when an output depends on a ratio, because dividing by a small number magnifies any change in it. Check the units first, then check whether the value you entered is in the range the relationship was designed for.