The trig calculator takes side length a, side length a, angle, angle β, angle β, angle β, area, side length b, side length b, sin, tan, cos, cot, sec, csc, mod, base angle, cot print, csc print and sec print and returns angle α, angle degrees print and side length c. It is built for quick answers, for checking somebody else’s arithmetic, and for the moments when a formula book is not within reach.
What Is the Trig Calculator?
The trig calculator works through side length a, side length a, angle, angle β, angle β, angle β, area, side length b, side length b, sin, tan, cos, cot, sec, csc, mod, base angle, cot print, csc print and sec print to give you angle α, angle degrees print and side length c.
It is aimed at the case where you know the method but not the arithmetic: schoolwork, a quick check on a worked example, or a figure that needs to be right first time.
How the Trig Works
Each step is applied in order and depends only on the values before it, which makes it possible to follow the calculation rather than take it on trust.
If you are working through the same problem by hand afterwards, compare the intermediate values. That is where a mistake usually shows itself.
Checking Your Own Working
Round sensibly as you go and keep the full precision in the calculator. Rounding too early is the most common way of getting a right method to give a wrong answer.
Where a result should be a whole number, such as a count, check it against the constraint that produced it. A fraction of a person is a sign that something upstream needs revisiting.
A Worked Example
Working through an example, with side length a set to 10, side length a set to 5, angle set to 2, the calculator returns side length c of 100.49876, and side length c (c2) of -19.74858, and angle α of -98.4292. Substitute your own figures and the same steps produce the same kind of answer.
Frequently Asked Questions
What do I need to work out angle α?
Enter side length a, side length a, angle, angle β, angle β, angle β, area, side length b, side length b, sin, tan, cos, cot, sec, csc, mod, base angle, cot print, csc print and sec print. The calculator then works through the relationship and reports angle α, angle degrees print and side length c.
What does the trig actually calculate?
It takes side length a, side length a, angle, angle β, angle β, angle β, area, side length b, side length b, sin, tan, cos, cot, sec, csc, mod, base angle, cot print, csc print and sec print and converts them into angle α, angle degrees print and side length c using the standard relationship for this problem. Each step is applied in turn, so every output is traceable back to the numbers you typed in.
How should I enter side length a?
Use the value you actually have, in the unit shown next to the field. Enter every value in the same unit system. The calculator assumes the figures you supply are consistent, so it cannot correct a mistake that happens before the calculation starts.
Does anything you type get stored?
No. The whole calculation runs inside your browser, and nothing you enter is uploaded, logged or sent anywhere.
Is the answer exact?
It is as exact as the formula and the inputs allow. The method itself is the standard one for this problem, so the only sources of error are the figures you enter and the precision you ask for.