Rip Rap Calculator

Everyday rip rap problems come down to one relationship between isbash constant (c), area, density, depth, gravitational acceleration (g), price per weight, specific gravity (s), wastage and water velocity (v). This calculator turns those numbers into average rock diameter (d₅₀), rip rap rock cost and total volume, with the working shown so you can check the result rather than simply trust it.

What Is the Rip Rap Calculator?

The rip rap calculator turns isbash constant (c), area, density, depth, gravitational acceleration (g), price per weight, specific gravity (s), wastage and water velocity (v) into average rock diameter (d₅₀), rip rap rock cost and total volume, so you can order the right amount of material the first time.

Material estimates are where projects go over budget. Getting the quantities right before the delivery arrives is worth more than any discount on the order.

How to Measure for the Rip Rap

Measure everything in the same unit and take the largest dimension you can reasonably use rather than the average. Formwork, ground conditions and cutting waste all push the real figure above the theoretical one.

Where a plan calls for a specific thickness, check it against local building regulations before you order. The calculator reflects the relationship, not the code.

Allowing for Waste and Errors

Order a little more than the calculation suggests. The gap between the theoretical quantity and what actually arrives on site is normally waste, spillage, over-excavation and uneven grading, and all of it comes out of the same budget.

Write the figures down and compare them with what you actually used on site. That is how you build an estimate you can trust for the next job.

A Worked Example

Working through an example, with isbash constant (c) set to 0.86, area set to 10, density set to 5, the calculator returns average rock diameter (d₅₀) of 16.90103, and volume of 20, and total volume of 20.4. Substitute your own figures and the same steps produce the same kind of answer.

Frequently Asked Questions

What do I need to work out average rock diameter (d₅₀)?

Enter isbash constant (c), area, density, depth, gravitational acceleration (g), price per weight, specific gravity (s), wastage and water velocity (v). The calculator then works through the relationship and reports average rock diameter (d₅₀), rip rap rock cost and total volume.

What does the rip rap actually calculate?

It takes isbash constant (c), area, density, depth, gravitational acceleration (g), price per weight, specific gravity (s), wastage and water velocity (v) and converts them into average rock diameter (d₅₀), rip rap rock cost and total volume using the standard relationship for this problem. Each step is applied in turn, so every output is traceable back to the numbers you typed in.

How should I enter isbash constant (c)?

Use the value you actually have, in the unit shown next to the field. Enter every value in the same unit system. The calculator assumes the figures you supply are consistent, so it cannot correct a mistake that happens before the calculation starts.

Does anything you type get stored?

No. The whole calculation runs inside your browser, and nothing you enter is uploaded, logged or sent anywhere.

Why does a small change in one value move the answer so much?

That happens when an output depends on a ratio, because dividing by a small number magnifies any change in it. Check the units first, then check whether the value you entered is in the range the relationship was designed for.

Scroll to Top