Whether you are estimating on the spot or checking a result somebody else gave you, the psi conversion calculator is the quickest way to get from pressure in bar to pressure in pounds per square inch, pressure in atmospheres and pressure in pascals.
What Is the Psi Conversion Calculator?
The psi conversion calculator converts pressure in bar between the units you need, so you do not have to hunt for a factor and work it out longhand.
Conversion factors are where unit mistakes happen, and a mistake here tends to propagate silently into everything calculated from it afterwards.
How the Psi Conversion Conversion Works
Each conversion uses the exact factor defined for the unit, so the answer is right to the precision you would normally quote.
Convert at one end rather than at several. Converting to a common unit first and then back again introduces rounding that you then have to carry through the rest of the calculation.
Getting the Units Right
Check that the unit you are converting from is the unit you actually measured in. Similar-looking units, particularly gallons and litres or ounces and grams, are the usual source of a factor-of-ten error.
Write down both the value and its unit. A number without a unit is not a measurement, it is a guess.
A Worked Example
Working through an example, with pressure in bar set to 10, the calculator returns pressure in pounds per square inch of 10, and pressure in atmospheres of 10, and pressure in pascals of 10. Substitute your own figures and the same steps produce the same kind of answer.
Frequently Asked Questions
What do I need to work out pressure in pounds per square inch?
Enter pressure in bar. The calculator then works through the relationship and reports pressure in pounds per square inch, pressure in atmospheres and pressure in pascals.
What does the psi conversion actually calculate?
It takes pressure in bar and converts them into pressure in pounds per square inch, pressure in atmospheres and pressure in pascals using the standard relationship for this problem. Each step is applied in turn, so every output is traceable back to the numbers you typed in.
How should I enter pressure in bar?
Use the value you actually have, in the unit shown next to the field. Enter every value in the same unit system. The calculator assumes the figures you supply are consistent, so it cannot correct a mistake that happens before the calculation starts.
Does anything you type get stored?
No. The whole calculation runs inside your browser, and nothing you enter is uploaded, logged or sent anywhere.
Why does a small change in one value move the answer so much?
That happens when an output depends on a ratio, because dividing by a small number magnifies any change in it. Check the units first, then check whether the value you entered is in the range the relationship was designed for.